spacer image spacer image spacer image spacer image spacer image spacer image spacer image spacer image spacer image
spacer image
Adhesives, laying and finishing

Step by step guide
spacer image
INSTALLATION
1.Sub floor preparation
spacer image
spacer image
spacer image
spacer image
spacer image
spacer image
spacer image
spacer image
spacer image
spacer image
spacer image
spacer image
CLEANING
   
Spraying adhesives
Mask painted surfaces from overspray. Place cut flooring in desired position.

Gently fold one half of flooring back and spray approved adhesive on flooring and subfloor as advised by supplier.

Unfold and apply the flooring to the subfloor, pressing down firmly to ensure full adhesion.

Repeat this process with the second half of the flooring.
spacer image Troweling adhesives
Place cut flooring in desired position.

Gently fold one half of flooring back and spread approved adhesive on exposed subfloor only, following manufacturer's timings and instructions fully.

Unfold and apply the flooring to the subfloor, pressing down firmly to ensure full adhesion.

Repeat this process with the second half of the flooring.
spacer image Finishing
To ensure flooring has 100% contact with adhesive, roll with heavy roller to remove trapped air. Push air bubbles to edges using hand roller.

Finally, trim around wheel wells and perimeter of floor.

N.B. When laying flooring, check that seams are cut straight and exactly butt together.

Do not pressure fit or allow gaps at seams or butt factory edges.

 
©Altro Group 2002.
Altro Transflor™, Altro Transflor Gallium™, Altro Transflor Tungsten™, Altro Transflor Meta™, Altro Transflor Chroma™, Altro Transflor Paint Box™, Altromastic™ are trademarks of Altro Limited.